技術公報
- AN#1 – Protocols for studying intercalation electrodes materials: Part I: Galvanostatic cycling with potential limitation (GCPL)
- AN#2 – Protocols for studying intercalation electrodes materials: Part II: Potentiodynamic Cycling with Galvanostatic Acceleration (PCGA)
- AN#3 – Galvanostatic Cycling with Potential limitation 4: Low Earth Orbit battery satellite protocol
- AN#4 – Potentiostat stability mystery explained
- AN#5 – Precautions for good impedance measurements
- AN#6 – Constant power technique (updated November 5, 2010)
- AN#7 – Application of the bipotentiostat to an experiment with a rotating ring-disk electrode.
- AN#8 – Impedance, admittance, Nyquist, Bode, Black, etc…
- AN#9 – Linear vs. non linear systems in impedance measurements
- AN#10 – Corrosion current measurement for an iron electrode in an acid solution (updated February 24, 2011)
- AN#11 – Calculation of the platinum’s active surface
- AN#12 – UV-Visible Spectroscopy and Electrochemistry coupling: Spectroelectrochemical experiment feasibility on a polypyrrol film
- AN#13 – VMP3 and Quartz Crystal Microbalance coupling: mass measurement during a polypyrrol film deposition
- AN#14 – ZFit and equivalent electrical circuits
- AN#15 – Two questions about Kramers-Kronig transformations
- AN#16 – Simultaneous Impedance measurements on each element of a running cell stack
- AN#17 – Drift correction in electrochemical impedance measurements
- AN#18 – Staircase Potentio Electrochemical Impedance Spectroscopy and automatic successive ZFit analysis
- AN#19 – EIS measurements with multisine
- AN#20 – Pseudo capacitance calculation (updated December 9, 2010)
- AN#21 – Measurements of the double layer capacitance
- AN#22 – Corrosion of reinforced concrete
- AN#23 – EIS measurements on Li-ion batteries – EC-Lab software parameters adjustment (updated December 9, 2010)
- AN#24 – Photovoltaic Characterizations: Polarization and Mott Schottky plot
- AN#25 – Multi Pitting Corrosion
- AN#26 – Graphic Customization
- AN#27 – Ohmic Drop: Part I: Effect on measurements
- AN#28 – Ohmic Drop: Part II: Introduction to Ohmic Drop measurement techniques
- AN#29 – Ohmic Drop Part III: Suitable use of the ZIR techniques?
- AN#30 – IMVS investigation on photovoltaic cell (updated June 8, 2010)
- AN#31 – Fuel Cell Testing – Part I: Overview and I/E characterizations
- AN#32 – Fuel Cell Testing – Part II: EIS characterization
- AN#33 – Supercapacitors investigations – Part I: Charge/discharge cycling (updated August 28, 2012)
- AN#34 – Supercapacitors investigations – Part II: Time constant determination (updated May 2, 2014)
- AN#35 – Application of the Capacitance-Voltage curve to photovoltaic cell characterizations
- AN#36 – VASP: An innovative and exclusive technique for corrosion monitoring
- AN#37 – CASP: a new method for the determination of corrosion parameters (updated October 20, 2011)
- AN#38 – Dynamic resistance determination. A relation between AC and DC measurements?
- AN#39-I – Electrochemical Noise Measurements – Part I : ASTM assessment and validation of the instrumental noise
- AN#39-II – Electrochemical Noise Measurements – Part II : ASTM assessment and validation on a real electrochemical system
- AN#39-III – Electrochemical Noise Measurements – Part III : Determination of the noise resistance Rn
- AN#40 – Differential (Incremental) Capacity Analysis
- AN#41-I – CV Sim – Simulation of the simple redox reaction (E) – Part I : The effect of the scan rate
- AN#41-II – CV Sim – Simulation of the simple redox reaction (E) – Part II : The effect of the ohmic drop and the double layer capacitance
- AN#42 – ZFit : The modified inductance element La.
- AN#43 – How to fit transmission lines with ZFit
- AN#44 – Artefacts in EIS measurements
- AN#45 – Using ZFit for multiple cycles analysis
- AN#46 – Dilatometer
- AN#47 – Corrosion current determination with mass transfer limitation
- AN#48 – Inaccuracy of the corrosion current determination in presence of an ohmic drop: EC-Lab® solutions
- AN#49 – EIS measurements: Potentio (PEIS) vs. Galvano (GEIS) mode, that is the question!
- AN#50-I – Math Reminder for electrochemists: I. The simplicity of complex number and impedance diagrams
- AN#50-II – Math Reminder for electrochemists: II. The simplicity of Laplace transform
- AN#51 – Supercapacitor characterization by galvanostatic polarization method – (.pdf 597 Ko)
- AN#52 – UFS-SEC: the spectroElectrochemical Cell for UV-Vis, NIR and IR measurment – ( .pdf 208 Ko )
- AN#53 – Precision and Accuracy in Coulombic Efficiency Measurements (.pdf 654 Ko). Sample data (.mpr 16 Mo).